Be Quiet! Dark Power Pro P11 550 W: from gold to platinum

[Behemot]

http://www.hardwareinsights.com/be-q ... -platinum/
Discuss the article here

[powernod]

Posted by Behemot
Trying to interrupt the power for 19.4 ms revealed that the hold-up time is slightly less, as can be seen on the image with the waveforms combined. It was 19.1 ms. This is still within specification but probably the lowest value so far.

So, if i can understand correctly, you mean that while "Hold-UP time" was 19.4ms, the "Power_OK signal" was 19.1ms?

[Behemot]

Voltage HUT, at that time I was not yet measuring the PG signal HUT. When I interrupted the power for 19.4 ms, the HUT dropped a bit, that's all.