HIGH QUALITY, HARD TO GET AND CUSTOM ELECTROLYTIC CAPACITORS FOR POWER SUPPLIES, DISPLAYS, TVs, MOTHERBOARDS AND MORE!

Power Logic Magnum Pro 315 Review

Discuss the Reviews and Articles on hardwareinsights.com here!

Power Logic Magnum Pro 315 Review

Postby c_hegge » January 31st, 2013, 1:52 pm

User avatar
c_hegge
Seasoned Veteran
 
Posts: 1632
Joined: March 16th, 2011, 8:45 pm
Location: North Coast, NSW, Australia

Re: Power Logic Magnum Pro 315 Review

Postby Wester547 » February 4th, 2013, 5:30 pm

In my opinion, it's below average. Maybe average in what's out there but below average in quality, for sure. Quality wise, an average PSU should have PI coils on the secondary and a bridge rectifier, I'd say... and certainly better input/transient filtering and output filtering otherwise. Obviously not the worst PSU you could get, but I wouldn't feel safe using it until it was recapped and had the appropriate improvements made to it. Besides, a 5/10 score is that of a failure. :P
Wester547
Veteran Member
 
Posts: 154
Joined: July 8th, 2012, 2:07 am

Re: Power Logic Magnum Pro 315 Review

Postby c_hegge » February 5th, 2013, 2:24 am

I know what you mean, but I just didn't see fit to knock more than what I did off because it it wasn't pushing the voltageas or ripple out of spec. There was still headroom on all of the rails, and I just can't see it being a problem in the real world (until the caps go bad, as you said).

Having said that, I agree that 5/10 is not a very good score, and I would not advise buying this power supply at all.
User avatar
c_hegge
Seasoned Veteran
 
Posts: 1632
Joined: March 16th, 2011, 8:45 pm
Location: North Coast, NSW, Australia


Return to Content Comments

Who is online

Users browsing this forum: No registered users and 39 guests