Wester547 wrote:>5mV
I think that's supposed to be <5mV.
Wester547 wrote:>5mV
I don't mean to necropost, but even in light of the worn out capacitors, you reviewed the HP-D3057F3H after you recapped the failed Teapos on +5VSB with Rubycon MBZ and Nichicon HE, and the ripple voltage on +5VSB, especially at the high loads, was much, much higher than it was even in the "before" polymod test (IE 3mV vs. 38mV...)... I didn't think the flyback section of the PSU, a completely separate part of the PSU, could be affected ripple wise by worn capacitors in the SMPS part of the PSU (the output of the forward converter) ? Or could it, since both sections of the PSU have different feedback?c_hegge wrote:2. They were different units and both were used. My guess is that the other one was older and had more worn out caps.
Users browsing this forum: No registered users and 87 guests